When there is no longer the need to shed water it will return Loaded left arm will automatically lower the height of theĪwning approximately 9 inches to allow water to run off. If water builds up on the awning, the spring Your A & E awning is designed to shed water if left out Important: As an extra safety precaution, visually You leave the awning unattended the awning Periods of heavy rain, or wind is expected or Press and hold the “Retract” button for 3 seconds and the awningĭurable and can be operated during light rain If the sensor isĪctivated or the retract button is depressed and theĪwning rolls up, damage to the awning and attachedġ. Important: Do not attach or hang any objects from This condition occurs, the bottom 2 wind speed LED’s will Note: Awning is not intended for cold weather operation.Īwning will automatically close when outside temperature Occur in high winds if the awning is left in the open position To de-activate the wind sensor feature, simultaneouslyĭepress and hold buttons 3 & 4 on the Remote Control Mounted in a storage compartment), simultaneously depress and hold buttons 1 & 2 on the Remote Control (KeyįOB) for 3 seconds. The wind sensor feature, locate the control box (usually When wind conditions are present that may damage theĪwning. Sensing device that will automatically close the awning The A & E WeatherPro awning is equipped with a wind This however, will not prevent the awning from “extension” mode is de-activated and awning will notĮxtend. When the ignition key is turned “ON”, the “extension” when vehicle ignition key is in the “ON” RV, this system is wired to prevent accidental awning The wind speed selection button until the desired To increase or decrease the sensor sensitivity, press and release The wind speed can be adjusted by pressing the Wind speed is preset from the factory at 18Ģ. The LED that is yellow indicates the wind speedġ. Indicates a communication fault between the windġ. When the LED is flashing Yellow and alternatesįlashing with the selected wind speed LED, this Time per second, this indicates that the voltage isīelow 10 (±.
When the LED is flashing Yellow at the rate of 1
That there is 12 VDC power at the control.Ģ. 12 VDC Power Indicator/Fault Indicatorġ When the LED is constant Yellow this indicates Important: When installed correctly on a motorizedĪ.
There are six (6) LED’s in the WeatherPro control and one The control box will automatically restore Wait approximately 30 seconds before depressing button again. Important: When the power has been interrupted, The sensing probe can be cleaned with a mild soap KeepĪirway clear of dust, insects, ice, snow, or other debris. Rectly if the airway to the sensing probe is clear. Important: The wind sensor will only function cor. The wind sensor is specifically designed to allow air to pass
If wind sensor is de-activated and damage to awning occurs, the awning warranty will be void. Obstructions in the proximity of the wind sensor can diminish the sensitivity. Three seconds the awning will remain in the position when button is To de-activate the wind sensor simultaneously press and hold buttons 3 & 4 To activate the wind sensor, simultaneously press and hold buttons 1 & 2 for
0 kommentar(er)
